A severe error occurred while using our EDS services component. This is probably due to a failed, or canceled download.ġ.
The files for installation requirement Rockwell Automation Driver Package 圆4 could not be found. I’m not sure if I installed it correctly, but it wasn’t part of the installer, as it had Its own installer which I ran and received following error: In our AB Software directory I found and installer for RSLogix Emulate 5000 (which was located in the installer directory of 21.03.01 Firmware support. Is SO_NOSIGPIPE not defined on Mac now? There are actually two places that use the same ifdef, one around line 810 and one around line 990 (the one you changed).I just recently tried to get into the whole RSLogix Emulate 5000 setup, for training purposes and setup. On the code change, did it not compile without that? I do not have a Mac, so the code is carefully stolen^H^H^H^H^H^Hborrowed from Stack Overflow. If it is a controller tag, then you just need the tag name. You are getting a solid session set up and then ForwardOpenEx is getting a completely valid (if not preferred) response back.Īssuming that we can get you past the connection problem, if the tag you are trying to get to is really a program tag, then you will need to access it with "PROGRAM.". It looks like this is quite close to working. It is actually the network module that implements a fair amount of the network protocol stack (AB never makes this easy!), so this seems possible. I seem to remember someone suggesting that you explicitly add a network module to the emulator and then use that IP address to access it. I think this is less likely as the error is fairly explicit but I could be translating the error incorrectly. This will tell the library that the PLC is a Micro800 family PLC which speaks a limited dialect of the protocol.
Perhaps the emulator only handles the older ForwardOpen packets. Usually 1 is the back plane, 2 is Channel A (if there is one), and 3 is Channel B (if there is one). If the port is not right, then perhaps you can try other numbers. It does look like the CPU should be in slot 1, so 1,1 would be what I would normally expect. The error you saw with the ForwardOpen is definitely what is causing the library to stop trying. I have had people try with the emulator in the past, but they did not get this far. Thanks for the questions and excellent data to show what you have done! In the future, please start a new issue so that others can search this.
0 kommentar(er)
